Retired Viking
Fish Connoisseur
I used a file to file mine down but sand paper works just as well.
Betta
- Thread starter Trandall
- Start date
🐠 May TOTM Voting is Live! 🐠
🏆 Click here to Vote! 🏆
Oh, ok. You can try to sand that down with a small piece of sand paper if you want to make it smoother. I did this with my cave when I first got it.
Bettas don’t really need caves, but they like them. I personally don’t like caves, but that’s my opinion. Try adding more plants or a nice piece of driftwood. My betta used to hide around his driftwood and rest on his Anacharis.
Ok, so I did a 50% water change and sanded down the log and cave and made sure there were no sharp edges on the plants. I also treated the water. I will let y’all know how it goes!
Retired Viking
Fish Connoisseur
good luck 
I agree with PheonixKingZ except do a 50-75% water change each day. Add a little aquarium salt too. One tablespoon for each 5 gallons of water to begin with. After that, each day if you do a 50% water change then add 1/2 tablespoon of aquarium salt back in. Has your filter been running since your other betta died or did it dry out in between. Did you clean the filter pad? If the pad stayed wet the whole time and you didn’t clean it with chlorinated tap water then it should be OK. We do need your water parameters though.
It has been running and I did clean the pad. I will look into getting a test kit and aquarium salt. I do use tap water but I treat it first and then let it run with the filter for a while before I put him back in. This is a cool group. I have always loved aquariums! But I definitely don’t have as much knowledge as you all.
You do not need to remove fish to do a water change, it is stressful for them doing this. Leave him in there but be aware of where he is in the tank while you are cleaning it.
I normally wouldn’t remove him for that but I wanted to make sure the water was ok. Is the stress coat/water dechlorinator supposed to work immediately?
If you are worried about it, leave the bucket of new dechlorinated water to stand for half an hour, or run an air stone in the bucket for 5 minutes. This is to make sure sure that every chlorine in the bucket comes into contact with a dechlorinator (Colin_T's advice). But most of us don't bother, we just put the dechlorinator in the bucket then run the water in at full speed, then put it in the tank.
What brand do you use? Because of the fact that I have small tanks, I use very clean milk jugs (plastic) for my water refills. I fill them with tap water first and then add my de chlorinator. (I use Tetra safestart what do you use?)
Tetra SafeStart claims it work instantly, but I don’t trust that 100%. I add the de chlorinator to the water (according to the directions on the back of the bottle) and then shake it up really good. I then wait a couple of minutes before adding it to my tank. Just my lite way of doing it after years of doing what didn’t work.
If you put the dechlorinator in the jug first, then add the water it'll start mixing as you are running the water
FishkeeperLinz
Fish Crazy
If you put the dechlorinator in the jug first, then add the water it'll start mixing as you are running the water
Agreed. That's what I do.
I do that too
Retired Viking
Fish Connoisseur
I fill the jug up 1/2 with cold water, add dechlorinator and fill the rest with hot water to get it close to the temp of the tank water.
I do that with my buckets
Most reactions
-
241 -
223 -
152 -
151 -
120 -
103 -
96 -
87 -
83 -
82 -
82 -
81 -
75 -
75 -
57
