Eheim 2128 Thermo External

[AncientMariner]

Hello,

Can anybody explain why my filter only leaks for a couple of minutes when it is first turned on, but then stops leaking & runs perfectly until the next time I turn it off /back on?

It is always at the back side of the filter head & like I say only for a couple of minutes probably trickling 2 pints worth out in the process.

Any advise appreciated..

 

[The-Wolf]

you may have a small crack/hole in the seal.
try replacing the seal and see if that makes a difference,
they are only a few quid so not an expensive option.

 

[AncientMariner]

you may have a small crack/hole in the seal.
try replacing the seal and see if that makes a difference,
they are only a few quid so not an expensive option.

Ok thanks - seen you can get a replacement gasket seal.

Lets hope thats all it is.

 

[helterskelter]

just use a little vasoline and that will stop it.

 

[AncientMariner]

just use a little vasoline and that will stop it.

Hi,

When you say use a little vasoline - where do you mean, on the outside edge or in/on the actual gasket seal within the head?

 

[helterskelter]

In the area it's leaking just skim a little over the gasket and then close.

That should be enough.

 

[The-Wolf]

that will however be a temporary solution though

 

[AncientMariner]

Ok thanks guys

I'm jumping the gun here a little - but if I do replace the gasket seal & it still leaks what other reason could it be? Or will it definately be the gasket?