Fluval 39"x24"x18" tank (drilled) - Capacity 283.7 litres
Dimensions 100w x 47d x 133cm height aquarium and cabinet
Hagen Fluval FX5 External Filter - Ceramic hoops/Filter wool as well as the sponge already around the fluval.
2 x 150W halide & twin blue actincs aquaspace light.
V2 1000 Skimmer - (Carbon in the outlet box (for easy changes)
Filled with R/O water (painfully slow doing this yourself but worth it ££ in the long run, as it only cost £55 of ebay for a new kit)
2 inches deep with white marine sand, then topped with 2 bags Live Sand
DIY - Nitrate Reactor
DIY - Phosphate Reactor
Circulating water around the tank with a Koralia 3
Calcium - I'll be using rowa kalk - until i decide on a calicum reactor...
Test Kit: Sera Aqua Test Box - Basically for the broad range of tests..
Today 20th March at around 11am after the halides where on for about an hour I collated the following test results:
PH :8.0
KH :8
NH4+NH3 :0.5mg/L
NO2 :0.0mg/L
NO3 :10mg/L
PO4 :0mg:L
Cu :0mg/L
Ca :400mg/L
Salt - Red Sea Coral Pro - Level currently at 1.024
I have not yet added any buffers..
Has anyone got any suggestions on how frequent i should perform these tests?
Thanks
Dimensions 100w x 47d x 133cm height aquarium and cabinet
Hagen Fluval FX5 External Filter - Ceramic hoops/Filter wool as well as the sponge already around the fluval.
2 x 150W halide & twin blue actincs aquaspace light.
V2 1000 Skimmer - (Carbon in the outlet box (for easy changes)
Filled with R/O water (painfully slow doing this yourself but worth it ££ in the long run, as it only cost £55 of ebay for a new kit)
2 inches deep with white marine sand, then topped with 2 bags Live Sand
DIY - Nitrate Reactor
DIY - Phosphate Reactor
Circulating water around the tank with a Koralia 3
Calcium - I'll be using rowa kalk - until i decide on a calicum reactor...
Test Kit: Sera Aqua Test Box - Basically for the broad range of tests..
Today 20th March at around 11am after the halides where on for about an hour I collated the following test results:
PH :8.0
KH :8
NH4+NH3 :0.5mg/L
NO2 :0.0mg/L
NO3 :10mg/L
PO4 :0mg:L
Cu :0mg/L
Ca :400mg/L
Salt - Red Sea Coral Pro - Level currently at 1.024
I have not yet added any buffers..
Has anyone got any suggestions on how frequent i should perform these tests?
Thanks