Recent content by Cichlid Marco 101

Does anyone know if Tenecor aquariums located in Arizona is still in business?????

thank you everyone. is this aquarium done . is the aquarium just a waste of my TIME ??????

OK, I should have metioned i have 3 40kg bags of sand in the aquarium.I measured the top brace that goes around toptop of aquarium it is still in square .I took my expensive level and the aquarium is sitting level.Have you heard of anyone use the aqueon clear aquarium silicone ??

I wonder if aqaurium shifted on my custom wood cabinet , I am thinking of putting some kind of thin rubber mat underneath the aquarium to make sure it stays level if it decides to shift

I am thinking to put aluminium pieces where i took those braces out . then reseal the aquarium again.glass could be permantley bowed ??. I was looking at trying the large tubes of aqueon aquarium silicone on Amazon.IT has tons of good reviews or am i just waisting my time with this aquarium now ?

Thank you , I may try that in the future

I have had an aquarists worst nightmare come true.so this aquarium i bought couple of yrs back and it sat for over 1yr.anyways when i bought the aquarium i knew i was going to have to reseal the aquarium again other than that there no visible damage to the glass chips cracks etc.I totally...

Thank you for the suggestions everyone.

I think i am going to cut a pieceof lexan to cover the top then just use wood lid to hide it

no glass lid between

I built a custom wood lid for my aquarium it was on on for 3 day when i noticed the lid was starting to grow mold even though the lid has been staind.I am wondering if i was use a piece of rigid foam on the underside and put 2 small fans in the lid if this would help keep air circulation and...

unit has been running for about a month now , very little air , Hw 3000 is nice quiet unit, I am happy with this unit doing a wonderful job keeping water crystal clear.I have a Sunsun 304b.I am actually very pleased with the Sunsun canister filters.cheaper name and they do an excellent job for...

Today , I took apart the sunsun HW 3000.just bought it 1 week ago.still air trapped in filter.So i put everything back inside canister filter made sure it was all in properly.put as much water inside canister as possible.hooked hoses back up made sure to keep outlet side closed .took blue cap...

I am not using the skimmer attachment

Thank you for your input , the impeller is working properly if i slow speed down it slows down if i turn speed higher it speeds up. seems most of the air is out i keep shaking the filter to break up the air, I might have to sit the filter a bit higher off the ground, I am going to give it a day...